Sonics VC100 100-watt (1992) User Manual download pdf (Page 8)

PREPARATION FOR USE

1. Ensure that the AMPLITUDE is set to OFF.

2. Plug the electrical line cord into the electrical outlet.

3. If the optional footswitch is used, insert the plug into the jack located on the rear

panel. Make sure that the plug is inserted forcefully all the way in.

4. If the converter / probe assembly is not already assembled; using the wrenches

provided, screw securely the probe into the converter.

5. Mount the converter / probe assembly in a laboratory stand, secure the clamp to the

upper section of the converter housing only. Do not secure the clamp to any other

portion of the converter / probe assembly.

6. Connect the converter cable to the power supply.

CAUTION

Do not operate an Ultrasonic Processor that has been in a very cold or hot

environment for a prolonged period of time. Wait until it has reached room

temperature

CAUTION

Never place a washer between the probe and the converter.

Never apply grease to the mating surfaces or threads of the converter, probe,

replaceable tip or microtip.

NOTE

Should it become necessary to remove a probe, use the wrenches supplied. If the

probe has been attached to the converter for a long period of time it might be

necessary to use a vise. Be sure the vise has soft jaws or other means to prevent

scratching. Secure the wide diameter portion of the probe in the jaws of the vise.

Never grip the converter in the vise. Using a wrench, twist the converter off the

probe. A tap of a hammer may be applied to the end of the wrench. Never attempt

to remove the probe by twisting the converter housing, as this may damage the

electrical connections within the housing.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

No comments

Sonics VC100 100-watt (1992) User Manual Page 8