Sonics 1098 Press User Manual download pdf (Page 13)

I N I T I A L E Q U I P M E N T S E T U P

ASSEMBLING AND MOUNTING CONVERTER, BOOSTER,

AND HORN

If the converter, booster, and horn are not already assembled, follow these

instructions:

1. Clean the mating surfaces of the converter and booster, as well as the

threaded stud and hole. Check that the stud is tight (see recommended

torque requirements on page 13).

2. Hand assemble the converter and booster together. Using spanner

wrenches as shown below, tighten until snug. Then, using a torque wrench,

tighten to 25-35 foot-lbs. (34-47 newton-meters). Do not force or

overtighten.

3. Clean the mating surfaces of the booster and horn, as well as the threaded

stud and hole. Check that the stud is tight. (See recommended torque

requirements on next page.)

4. Hand assemble the horn to the booster. Using a spanner and an open-ended

wrench as shown below, tighten securely. Then, using a torque wrench,

tighten to 25-35 foot-lbs. (34-47 newton-meters). Do not overtighten.

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

I N S T R U C T I O N M A N U A L • M O D E L 1 0 9 8

CONVERTER/BOOSTER

CONVERTER/BOOSTER/HORN

Never tighten the horn to

the booster using the

housing door as the upper

wrench as this may cause

damage to the booster

and/or converter.

Go To Top Of Document

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 26 27

Comments to this Manuals

No comments

Sonics 1098 Press User Manual Page 13

Comments to this Manuals

Related products and manuals for Equipment Sonics 1098 Press